ウォール

Nathan Dempsey
Watching 👀

Alberto
Nice interior. That is going to be rather big I would say!

Ronald Clanton 著者
Yes, it is large! Not sure where I will display once it's done.

Cristian A
beautiful result, I don't usually build WW2 aircraft, but this sparked my interest in one 🙂

Guy Rump
Great camo, really impressive. 👍

Marcos Freitas
Nice job to a great bird

Paul Lw
Perfektion!

Guy Rump
Very impressive build, insignia and numbers painted is something I've never attempted, great results! 👍

Ronald Clanton 著者
Thanks! I'm starting to use my Brother Scan N Cut to make the stencils/masks. I'm starting to figure out how to paint them properly and reduce the amount of "bleed" that can occur. Fun stuff!

Ray Loch
Very Nice build! Quick question, how did you find Eduard's decals as your application turned out great.

Ronald Clanton 著者
Firstly, this is my seventh model build... so not an expert. However, this was the worse kit so far. The pieces didn't always fit right, lots of filler, panel lines poor, and landing gear attachment sketchy. It makes me wonder about the great reputation of Eduard... but perhaps it's just me? I've had great luck with Tamiya and Airfix kits.

The main insignia (meatball and stripe) were painted with hand-made stencils. I found the Eduard main decals very poor. The number on the plane was not the one I intended to use, but their decals floated off the paper almost immediately and folded on itself. I could not repair. Then the next number set was transferred to the plane and immediately stuck... unable to move. I used Micro-Set/Sol and still no joy. Interestingly, the smaller decal sheet (with smaller items) worked fine. Very frustrating. I hope others have better luck.

Ray Loch
Hi Ronald, thanks for taking the time to give this detailed feedback. I personally haven't dealt with Eduard's newer decals, after hearing some horror stories I was impressed how good yours look and now it makes sense that you painted yours. Even with the issues a great looking build.

Guy Rump
Very nice build, congrats! 👍

gorby
Nice result, although personally I think it would look better with a thinner aerial wire.

Ronald Clanton 著者
Agreed. It was my first time adding an aerial wire on a model. I used the recommended EZ Line size... but now have ordered the thinner size for my next model.

Guy Rump
Great job on the P-40, congrats! 👍

Vincent
Great result. I really like the scheme also!!

Rui S
Very nice work 👍

Neuling
Clean and careful work! 👍

Ronald Clanton 著者
Thanks! Still learning...