Patrick Hagelstein
In! 😄

Ulf Krahn
Nice!

Treehugger
I would recommend getting those anti reflective stickers, looks very nice if you can make sure the backside is fully smooth and also fully flat. Any bending of the sticker piece will stand out if it isn't smooth and also flat. Although such stickers are made for individual tanks, the ones I have have extra areas that you can use for cutting out custom shapes. Apparently different tanks have different types of coloring to their optics but I am no expert.

Mirko Römer
Following!

Mattias Björk
To quote odd ball from Kelly's Heroes ... a mother beautiful tank!

Mattias Björk
Do you know roughly how much time you have spent on it so far?

Karel Doležal Autor
Without the etchings I could glue the model together in a week. With the included etchings, an extra two weeks. Of course, free pace in the evenings and on weekends.

Jos Jansen
Always in concerning Leopards 😄

Moritz Fentzahn
Count me in. Looking very promising. Good work on the PE

Christian W
I don't know, how far you are with the built up. But if you still have the option to change the routing of the cables at the back, then do it. Because they don't cross on the A7. Pay attention to the carton picture! It's clearly visible there. The routing is designed so that the on-board intercom can still be operated from the middle at the rear. With crossed cables, it's impossible to open the box.

Karel Doležal Autor
Thanks for the tip. I haven't finished the model yet, so I still have a chance to change it. This is just a temporary installation. But I've done it so that it doesn't interfere with the intercom. Attached is a current photo of the rear.

Guy Rump
Looking great, following. 👍

Christian W
That solution works too 😉 !