Vlákno založeno Ponytail4
přidal nové fotoalbum.
36 obrázky
Heinkel He-111P
1:72
I'm going to stop here at this point while I figure out why my airbrush is spraying off center, before continuing with t...
Projekt: 1\72 Heinkel He-111P
51 15 March, 03:29
Great job!
But as a result, the Presheading is almost invisible on the model.
It usually happens to me too.
1 15 March, 11:07
Did you figure out why your airbrush was painting off center? When this happens to me its usually because there is a clog or the needle tip got bent. What happened with yours?
1 16 March, 12:25
I took the airbrush completely apart and soaked it in a cleaning bath overnight. There was a lot of build-up inside the brush (Mainly the trigger section). But after the bath I inspected the parts for damage as I cleaned them off. Some areas needed a toothpick to be used to scrap clean some internal sections. I'll test today and go from there. I'm lucky in the fact that there is store a few minutes away that carries spare parts for this brand of airbrush. If was one of my more expensive airbrushes, I would be waiting weeks for spare parts.
16 March, 14:55
Sometimes an off center spray can be the results of a bent pin or paint buildup in the internals. I bet a breakdown and a through cleaning will solve the problem. I spend more time cleaning my airbrush after a painting session than the time it took to paint but it's time well spent to avoid mishaps and headaches. Good luck
1 18 May, 17:02
I solved the problem. My airbrush just needed a really good cleaning and while I was at it I replaced some worn O-rings in the process. Seems to be running smoothly again.
18 May, 17:08
I am waiting like ages to build this kit and here you finish it exactly like how i would done (in another 5 years i hope.) Congtars, she a real beauty, good paint job, clean and tidy!
1 24 May, 15:21






