Zlin Z-43 Sanitka, 1/72

One side of the interior had to make room for the stretcher. 🙂 

In most photos, the elevator is tilted down. So I cut the part in two.  

I will glue both doors on the right side in the open position. 

 

I was thinking about narrowing the sidewalls ... but then I said to me "don´t take it so seriously". 🙂 

I had to lower the back compartment horizontal plane, because it is too high in the model.  

The end has to be cut if I wanted the elevator to be in tilted down position 

Five grams of lead is enough 🙂 

Part of lead put from the cockpit side 

Lead put in front  

Main gear legs glued in because I needed to check how many lead I need to put in front to prevent model to be a tailsitter. 

 

 

 

 

I made me a simple printed dashboard,